Koch Chemie Spotless Ceramic Finish SCF Water Spot Remover and Care Treatment for Ceramic Coatings

Koch Chemie Spotless Ceramic Finish SCF is a water spot remover and care treatment for ceramic coatings, supplied in a 0.5 litre bottle. It targets predominantly calcium-based mineral deposits and the white or grey film formed by water spots, making it suitable for treating residual stains that affect the appearance and feel of coatings after washing.

The formula has a pH of 7.5, focusing on gentle deposit removal and maintenance of the existing sealant or coating. Left on the surface for up to approximately 3 minutes, it helps soften and dissolve limescale, reducing white marks and streaks caused by mineral deposits or environmental contamination to restore colour depth, gloss and a smooth feel.

Preparation before use: if the surface is heavily contaminated, carry out appropriate deep cleaning first. For coated vehicles, first use a pre-wash product such as Green Star to remove surface dirt, then wash according to the Reactivation Shampoo instructions to reactivate the coating. After rinsing thoroughly, completely blow-dry or towel-dry the surface before applying SCF.

1. Spray onto a cloth: Apply SCF sparingly to a microfibre cloth so that the cloth is moist.Do not spray large amounts directly onto the paintwork.
2. Apply: Using the dampened microfibre cloth,apply evenly to the area to be treated.
3. Dwell time: Depending on the severity of the limescale, allow the product to remain on the surface for up to approximately 3 minutes to soften and dissolve the limescale.Never allow the product to dry on warm surfaces or surfaces in direct sunlight.
4. Wipe off: Use a professional microfibre cloth to buff thoroughly and remove any residue; if necessary, wipe again with another clean, dry cloth to ensure a streak-free finish.
5. Check: Check the results after treatment; if stubborn limescale remains, as appropriate,repeat the steps or carry out deeper cleaning before treating again.💡 Professional tips

:

1. Clean before treating: Before using SCF, complete the car wash process to ensure the surface is free from dirt and existing residue for better results.
2. Avoid direct sunlight

:

Do not use in direct sunlight or on hot surfaces to prevent the product from drying too quickly and leaving marks.

3. Combine with coating maintenance: After removing limescale, use CarPro Reload 2.0 or Koch-Chemie Spray Sealant S0.02 Bodywork Coating Spray to reinforce the coating's protective layer.
4. Differences from CarPro Spotless 2.0 explained

:

Koch-Chemie SCF is specifically designed for ceramic-coated vehicles,with a neutral pH of 7.5 that does not damage coatings;CarPro Spotless 2.0 is more acidic and suitable for removing stubborn limescale spots, but note that it cannot be used on all coatings.

• Automotive paintwork; can be used easily on the brand's ceramic coatings Cb0.01 and C0.02.

Shake well before use. Protect from frost and excessive heat. Check suitability and compatibility before use. Do not use on warm surfaces or in sunlight.

Ingredients listed in Section 3 of the Safety Data Sheet (extract, not the complete formula):

• 2-(2-Butoxyethoxy)ethanol: 10-<25%

Delivery available to a specified address, SF Locker or convenience store; free delivery on discounted goods totalling HK$200 or more, otherwise delivery charges are payable on receipt.