Soft99 Glaco DX

Soft99 Glaco DX focuses on lasting water repellency and ease of application. It uses SARF (Strong Adhesion/Rapid Finish) technology to form an even coating, reducing resistance as raindrops slide across the glass and helping to minimise residual droplets. The fluorine-free formula provides water repellency lasting approximately four months.

The 'rocking applicator head' and 'wide rectangular felt pad' allow the contact surface and angle to be adjusted. Even on near-vertical glass, the coating liquid is easy to dispense and apply. Suitable for users who value easy application to glass at different angles.

Capacity: 110ml, sufficient for multiple applications. The coating helps reduce the adhesion of oily film, snow, frost and dirt, while also helping to lessen the effects of UV rays, condensation and winter icing. Apply to clean glass, then wipe with a cloth to complete the treatment.

https://www.youtube.com/embed/DPvLGJlSTlY

※Before application, thoroughly remove dirt and dust from the glass with water and allow the glass to dry completely※Turn the screw cap anticlockwise and remove the transparent cover①Place the felt pad against the glass to prevent splashing, gently squeeze the bottle to release the coating liquid, and saturate the entire felt pad②Adjust the flow of coating liquid as needed during application and avoid leaving any areas untreated※Applying in overlapping vertical and horizontal strokes helps prevent missed areas③Leave to dry for approximately 5-10 minutes, then wipe clean with a well-wrung damp towel※Failure to wipe thoroughly may cause poor visibility or wiper judder

• Automotive glass.

• ＜Application precautions＞
• Do not allow the liquid to contact surfaces other than glass. If it accidentally gets onto paintwork, wipe it off promptly to prevent possible paint peeling.
• Do not point the felt pad towards anyone when opening the cover.
• Keep the felt pad away from your eyes when opening the cover to prevent exposure to any liquid spray.
• Do not use in strong direct sunlight or when the glass is hot.
• Avoid application at temperatures below 10℃. Alternatively, switch on the heating or heated glass demister and allow the glass to warm up before application.
• Water droplets on the glass may prevent the product from performing as expected. Wipe the glass dry and allow it to dry completely before application.
• Applying too much product, or applying it over other coatings or oily film, may cause the liquids to repel one another.
• On first use, other coatings or oily film on the glass may prevent the product from performing as expected. Clean with an abrasive cleaner sold separately before use.
• To avoid difficulty wiping off the product or leaving residue, do not leave the coating on for an extended period without wiping it off.
• To avoid scratches, check the felt pad for grit or other foreign matter before application. If excessive grit or other foreign matter is found, remove the pad, wash it with water and allow it to dry completely before refitting and using it. (Residual moisture may prevent the product from performing as expected.)
• Applying excessive pressure may cause damage.
• After use, replace the transparent cover and tighten the screw cap before storing. (Overtightening the screw cap may cause damage.)
• Do not apply to areas other than those specified in the intended uses.
• This product is a coating for glass only. Do not use on transparent plastics such as headlight covers, helmet visors, spectacles or diving goggles.
• Check your vehicle's owner's manual before use.
• A large temperature difference between the inside and outside of the vehicle may cause temporary white misting immediately after the wipers pass. Please take care.
• Check the wiper rubbers, as deterioration may cause wiper judder during operation. Always replace deteriorated wiper rubbers. ('Glaco' wipers are recommended.)
• Do not use on the inside of glass.
• Do not use on specially treated glass or rear-view mirrors.
• Wash your hands thoroughly after use.
• Coating durability varies depending on usage conditions. Reapply when water repellency weakens.
• Do not use screenwash containing oily film removers. Use clean water or water-repellent screenwash, such as 'Glaco' screenwash.
• Do not inhale or drink: harmful to the human body if inhaled or swallowed.
• Avoid contact with eyes or skin. People with sensitive skin may experience skin irritation. Wear gloves during application.
• Flammable. Keep away from sources of ignition.
• In backlit conditions or when emerging from dark places such as tunnels, the glass may temporarily turn white. Take care and use the wipers immediately to ensure clear visibility.
• Keep out of reach of children and people with suspected dementia.
• If swallowed accidentally, do not induce vomiting. Seek medical attention immediately.
• If the product accidentally enters the eyes, rinse thoroughly with clean water for at least 15 minutes. If any abnormalities occur, seek medical attention promptly. If you feel unwell during use, stop using immediately. If symptoms persist, seek medical attention promptly.

Alcohols, silicones, acid

Delivery is available to a specified address, SF Locker or convenience store; free delivery on discounted goods totalling HK$200 or more. Below this amount, delivery charges are payable on receipt.